Digitrax DZ123M0 매뉴얼 - 페이지 2

{카테고리_이름} Digitrax DZ123M0에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitrax DZ123M0 8 페이지. Fits microtrains zgp-35 locomotives, z scale, mobile decoder dcc plug 'n play 1 amp/1.25 amp peak 2 fx3 functions, 0.5 amp

페이지 인쇄

P P a a r r t t s s L L i i s s t t

1 DZ123M0 Decoder

I I n n s s t t a a l l l l a a t t i i o o n n I I n n f f o o r r m m a a t t i i o o n n

See the Digitrax Decoder Manual for complete decoder test procedures, instal-

lation instructions, programming and technical information. Digitrax manuals

and instructions are updated periodically. Please visit www.digitrax.com for the

latest versions, technical updates and additional locomotive-specific installation

instructions.

I I n n s s t t a a l l l l a a t t i i o o n n I I n n s s t t r r u u c c t t i i o o n n s s - - M M i i c c r r o o T T r r a a i i n n s s G G P P - - 3 3 5 5 L L o o c c o o m m o o t t i i v v e e

1. Carefully remove the locomo-

tive's shell from the frame.

Notice the orientation of the

shell for reinstallation.

Figure 1.

2. Carefully remove the motor

springs with tweezers. Store

these springs in a safe place

for later re-use Figure 2.

3. Slide the factory light board

forward to release it from

under the clips on the locomo-

tive frame. Be careful not to

distort the frame clips as you

slide and lift the light board off

the frame. Figure 2.

4. Take the DZ123M0 decoder

(noting the correct orientation

of the frame pads) and slide

underneath frame clips as indi-

cated in the Figure 3. You will

need to gently flex the front of

the decoder in order to clear

the GP-35's retaining post

(partially shown).

5. As shown in Figure 4 reinstall

the motor springs, taking care

to insure the springs do not

touch the loco frame. Finally

reinstall the locomotive shell.

6. Place the locomotive on the

track, select address 03 on

D D

C C

i i g g i i t t r r a a x x

o o m m m m a a n n d d

R R u u n n Y Y o o u u r r T T r r a a i i n n s s , , N N o o t t Y Y o o u u r r T T r r a a c c k k ! !

Figure 1:

Remove loco shell

Figure 2: Remove two motor springs

with tweezers - store in safe place

underneath frame clips

Retaining post

Figure 3: Installing Decoder in frame.

www.digitrax.com

C C

o o n n t t r r o o l l

1 Instruction sheet

Light Board

Frame Clips

Insure decoder is

firmly inserted

Spring Pads

Frame screws

Flex front of decoder

to clear front post