Digitrax DZ126IN 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Digitrax DZ126IN에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitrax DZ126IN 12 페이지. Complete train control

Changing the Decoder Address

The first CV most people change is the decoder address. This allows you to inde-

pendently control each loco with a unique address. Digitrax decoders are shipped

with CV01 (AD2), the two digit address, set to 03. Following is a brief description

of how to change the decoder address with a Digitrax DT4XX series throttle. See

your Starter Set Manual for complete programming instructions.

Place the loco on the programming track not to exceed 16V. Go into

Program Mode on your system. On DT4XX throttle press PROG.

Choose AD2 for 2 digit addressing or AD4 for 4 digit addressing.

Choose the address you want to set up for the decoder.

Complete address programming by pressing ENTER.

Note: CV29 must also be programmed to enable 4 digit addressing, this is done

automatically by the DT4XX throttles. See your Digitrax Decoder Manual or the

Digitrax Toolbox App for how to set up CV29.

Digitrax LocoMotion

Your locomotives look like the real thing, now you can make them run like the

real thing, too. Digitrax decoders incorporate torque

compensation for smooth as silk operation. You can also program CVs that

control momentum, 3 step and 128 step speed tables, switching speed, normal

direction of travel, scalable speed stabilization and more to take full advantage of

the Digitrax LocoMotion System.

Momentum-CV03 & CV04

Momentum is part of the LocoMotion System. Acceleration is controlled by CV03

and deceleration by CV04. Both come from the factory set to 000. A range of 000

to 031 is available for both accel and decel. Try CV03:003 and CV04:000 as a

starting point for experimenting with momentum.

System

— 5 —