argon audio TT 매뉴얼 - 페이지 8
{카테고리_이름} argon audio TT에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. argon audio TT 9 페이지.
argon audio TT에 대해서도 마찬가지입니다: 빠른 시작 (2 페이지)
페이지 인쇄
- 1. Components, Features and Connections
- 2. Items Included in the Box
- 3. Turntable Platter and Belt Setup
- 4. Cartridge Downforce Adjustment
- 5. Connection to Amplifier/Speakers
- 6. Main Power Connection
- 7. Turntable Operation
- 8. Maintenance and Cleaning
- 9. Cartridge Replacement
- 10. Technical Specifications
- 11. Troubleshooting
- 12. The Platter Doesn’t Turn Although the Unit Is Switched on
- 13. No Signal through One or Other Channel or both Channels
- 14. Distorted of Inconsistent Sound from One or both Channels
T T M a n u a l
Troubleshooting
The platter doesn't turn although the unit is switched on:
- Drive belt is not installed or has slipped off.
- The unit is not connected to the main power supply.
- No power at the outlet.
No signal through one or other channel or both channels:
- Wrong input selected at amplifier.
- Amplifier is not switched on.
- Amplifier or speakers muted.
- No connection to the speakers.
- No connection between turntable and amplifier.
- Wire leads not connected the cartridge.
Strong hum on phono input:
- No ground connection from cartridge, arm, or arm cable to amplifier or ground loop.
- Turntable too close to speakers or other electrical noise
Distorted of inconsistent sound from one or both channels:
- Turntable is connected to wrong input of amplifier.
- Needle or cantilever damaged.
- Drive belt overstretched or dirty.
- Platter bearing without oil, dirty or damaged.
- Dust on stylus.
- MM / MC switch on pre-amplifier set incorrectly.
7