argon audio tt-2 사용자 설명서 - 페이지 12
{카테고리_이름} argon audio tt-2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. argon audio tt-2 12 페이지.
argon audio tt-2에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지), 소유자 매뉴얼 (12 페이지)
페이지 인쇄
Troubleshoot - Potential incorrect use and fault conditions
Argon Audio turntables are manufactured to the highest standards and undergo strict
quality controls before leaving the factory. Faults that may possibly occur are not
necessarily due to material or production faults but can sometimes be caused by
incorrect use or unfortunate circumstances. Therefore the following list of common fault
symptoms is included.
The platter doesn't turn although the unit is switched on:
• The unit is not connected to the mains power supply.
• No mains at the socket.
• Drive belt is not fitted or has slipped off.
No signal through one or other channel or both channels:
No signal contact from the cartridge to the internal tonearm wiring or from that to the
arm lead or from that to the phono box or between that and the amplifier. This could
be due to a faulty plug, broken wire or solder joint or simply loose plug/socket
connection.
• Phono input not selected at amplifier.
• Amplifier not switched on.
• Amplifier or speakers defective or muted.
• No connection to the loudspeakers.
Strong hum on phono input:
• No earth connection from cartridge or arm or arm cable to amplifier, or earth
loop.
Distorted or inconsistent sound from one or both channels:
• Record player is connected to wrong input of amplifier, or MM/MC switch
incorrectly set.
• Needle or cantilever damaged.
• Wrong r.p.m., drive belt overstretched or dirty, platter bearing without oil, dirty
or damaged.
w w w . a r g o n a u d i o . c o m
T T 2
12