Digitrax SoundFX SDH187MT 매뉴얼 - 페이지 3

{카테고리_이름} Digitrax SoundFX SDH187MT에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitrax SoundFX SDH187MT 12 페이지.

Note: The SDH187MT does not include a speaker. This install is shown with an

optional SP26158BC. Please refer to your locomotive information for the best

way to attach a speaker to you locomotive motherboard, if there is no existing

speaker.

Inspect the installation before testing the sounds and replacing the shell. In

particular be sure that wires are correctly routed and not pinched between

the shell and frame.

Place the loco on an active DCC track powered by a compatible DCC system

and select the factory default address 03 to enable sounds for testing.

Be sure F8 (mute) is OFF to allow sound output, and then press

F1 (bell) or F2 (whistle/horn) ON to hear the associated sounds.

Customize sounds by programming Sound CVs to adjust the desired con-

figurations, as shown in the following tables of SoundFX CVs. Sound

schemes other than the 2 factory preloaded can be loaded by using a Digitrax

PR3,PR4,DCS52, DCS210+,DCS240 or DCS240+ in conjunction with the

free Digitrax SoundLoader app from the Digitrax Sound Depot.

8. Figure 2 shows a typical US locomotive where the original analog jumper

board has its 21-pin black socket body on the "top" as shown. The decoder

should exactly match this arrangement chosen by the manufacturer. The 21

pins on the host locomotive main board must first enter through the holes

on the green decoder board, and not directly into the black socket. There is a

single index pin skipped to indicate alignment. This 21MTC arrangement is

not symmetric, and must be followed exactly, otherwise decoder damage not

covered by warranty may occur.

— 3 —