Digitrax PM42 매뉴얼 - 페이지 3

{카테고리_이름} Digitrax PM42에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitrax PM42 16 페이지.

1.0 Introduction

The PM42 can control 4 independent power sub-districts that can each be set

up as either a "Short Circuit Manager" (default) or an "Auto-Reversing

Controller." Each of the 4 sub-districts can be set for slow, regular, faster or

fastest short circuit management depending on the needs of the user. A separate

booster can power each of these sub-districts or multiple boosters can power

any combination. Each PM42 requires a 12 to 18V AC or DC 125mA power

supply (sold separately such as Digitrax PS14). One power supply (125mA per

PM42) can power more than one PM42 as long as it provides 125mA per

PM42 and is not used to power any other device. DO NOT share a power sup-

ply between your PM42 and any command station or booster on the layout.

Digitrax does not recommend sharing a power supply between one or

more PM42s and any other device on the layout.

Analog operation or zero stretching will adversely affect booster or PM42

detection times for auto-reversing and short circuit detection.

Power District or District: The power wiring, components and equip-

ment attached to that wiring that are driven from a single properly

isolated booster. In the case of the PM42 a district is a part of the

layout that is double gapped at both ends and powered by a single

booster.

Sub-district: A subdivision of a district. With one PM42, you can create

4 sub-districts. These 4 sub-districts can all be within one district

district.

Section: One fourth of a PM42. Each PM42 is divided into 4 sections.

We call these Section 1, Section 2, Section 3, and Section 4. Each

section of a PM42 can be set up either for short circuit management

or auto-reversing.

When the PM42 detects a short circuit, it will shut down the sub-district where

the short occurs. The "SUB-DISTRICT STATUS" LED for the sub-district with

the short circuit will light red. The other sub-districts will continue to operate.

PM42 reconnection or automatic restart attempts may cause brief power inter-

ruptions to the booster output if the short circuit is not cleared.