B.M.C. CS2 소유자 매뉴얼 - 페이지 8
{카테고리_이름} B.M.C. CS2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. B.M.C. CS2 8 페이지.
페이지 인쇄Remote Control
Use the AMP section on top of RC-1 for the classical
Amplifier mode
VOLUME +
mute
Increase the sound volume
IN
VOL
AMP
VOLUME -
Decrease the sound volume
disp
rep.
MUTE
clear
prog
check
Mutes the signal.
Unmute by pressing MUTE again.
1
2
3
MUTE will not be cancelled by changing volume,
only by pressing MUTE again!
4
5
6
INPUT UP / DOWN
7
8
9
Changes to the next / previous INPUT
0
+10
CD
Use VOLUME and MUTE of the DAC section of
RC-1 for the B.M.C. chain mode with Volume
controlled by the B.M.C. DAC
df
ovs
ups
DAC
BATTERIES
VOL
IN
If the operating range of the RC1 remote control
mute
decreases, change the batteries of the remote
control to new ones.
Open and close the battery case with a TORX-10
screwdriver.
Insert new batteries of type AA / Mignon in correct
+/- polarity.
RC-1
Alkaline batteries may be used as well as
rechargeable NiMH, but never mixed.
Troubleshooting
Whenever you suspect a malfunction of the unit, please first check a possible cause by
proceeding the below list, before contacting your local dealer or the B.M.C. Audio
service.
No Function or Display
·
Check the AC-power cable is connected at both sides.
·
Make sure there is AC power available at the wall outlet.
·
Check the power switch position.
ERROR displayed
·
An internal error occurred. Please switch off the unit, wait at least 1 minute, and
switch on again. If error occurs again, switch off the unit and contact your dealer or
B.M.C. Audio service center.
No music
·
Check the interconnections of the audio system
·
Check the function of the signal source
·
Check the amplifier input and volume setting
Remote control non-functional
·
Aim at the middle of the display from short distance
·
If the operating range decreases, change the batteries of the remote control to
new ones of type AA
Note: The CS2 has a micro-computer inside which may "hang-up" due to static
discharge or other voltage sparks. In this case power off the unit, wait for about 1
minute and power on again.
Maintainance
·
The CS2 requires no user maintenance.
·
Clean the unit with a dry micro-fiber cloth only.
·
Take special care not to scratch the acrylic window.
Service
In case you have to contact the B.M.C. Audio Service Center, please prepare the
following information:
·
Model-name, serial number and date of purchase.
·
Name, tel. and address of the dealer.
·
Precise description of the malfunction.