B.one B1MS02-ZW-AU 매뉴얼 - 페이지 4
{카테고리_이름} B.one B1MS02-ZW-AU에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. B.one B1MS02-ZW-AU 9 페이지.
페이지 인쇄
Removing
1) Open the cover.
2) Place the device within the direct range of your Z-Wave controller.
3) Set the main controller remove mode (see the controller's manual).
4) Triple click the Z-button quickly, the LED indicator should blink fast.
5) Wait for the removing process to end.
6) Successful adding will be confirmed by the Z-Wave controller's message.
Ⅳ. Functions of each trigger
Function of Action Button:
B.One Motion Sensor is not in the Z-Wave network:
Trigger
Short press 1 time
(within 1 second)
Short press 3 time
(within 1 second)
Press and hold for 1-
3 seconds
Press and hold for
more than 3 seconds
B.One Motion Sensor is in the Z-Wave network:
Trigger
Short press one time
(within 1 second)
Short press 3 time
(within 1 second)
Press and hold for 1-
3 seconds
Press and hold for 3-
20
seconds
Press and hold more
than 20 seconds
Description
1. Led will blink fast.
The same as "Short press 1 time"
Led keeps on when holding the Z-Button, turn off when Z-Button is
released.
1. Led blink fast then turn off;
Description
Led will keep on for 1 seconds
1. Led will blink fast;
2. Remove for exclusion;
Led keeps on when holding the Z-Button, turn off when Z-Button is
released.
1. LED will blink fast.
2. Motion Sensor will send "wake up notification command" to the
nodes which is assigned by "Wake Up Command".
3. Motion Sensor will enable/disable "awaking for 5 minutes function".
Reset Motion Sensor
Triggering this action, led will keep on until the Z-Button is released;
Motion Sensor will send "Device_Reset_Locally" to the main controller