3Com MSR 30-16 릴리스 노트 - 페이지 15
{카테고리_이름} 3Com MSR 30-16에 대한 릴리스 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com MSR 30-16 17 페이지. Safety and compliance information (v1.01)
3Com MSR 30-16에 대해서도 마찬가지입니다: 안전 정보 매뉴얼 (12 페이지)
페이지 인쇄
3Com MSR Family Release Notes
Release Notes Software v5.20
Select option 6 to exit to the Main Boot Menu and then reboot the router from there.
Be sure to change the baud rate of the console terminal back to 9600 bps, disconnect, and re-
dial if it was changed to speed up the download. Then you can see the system reboot in
progress.
3.4
Upgrading Software Using TFTP (option 1)
Use the following procedure to upgrade the software with TFTP:
1
You must have level 3 privileges.
2
In the User View, enter: tftp <server ip address or hostname> get <filename>.
3
Enter the System View.
4
Set the router to boot from the new image using "boot main <filename>".
5
Exit the System View.
6
Reboot the router.
The following example illustrates this procedure:
<MSR-50>tftp 172.16.1.254 get msr50-cmw520-b1508p01-si.bin
File will be transferred in binary mode. Downloading file from remote
tftp server, please
wait..................................................................
.......................................................................
........................................................./ TFTP:
18337204 bytes received in 194 second(s).
File downloaded successfully.
<MSR-50>boot-loader file msr50-cmw520-b1508p01-si.bin main
This command will set the boot file. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next
reboot!
<MSR-50>reboot
3.5
Upgrading Software Using TFTP (option 2)
Upgrading the application image with the Ethernet SubMenu will use an Ethernet interface to
download the application. In this approach, the router is the TFTP Client and needs to connect
to a TFTP Server using a fixed Ethernet interface. The following describes how to upgrade the
application image with this approach:
1
Start the TFTP Server on the host connected to the Ethernet interface on the router. Set the
path for the source file to be downloaded.
Caution: No TFTP Server is available on the routers. You must have a TFTP server available.
2
In the Boot Menu, select option 3 to enter the Ethernet SubMenu (shown below):
====================<ETHERNET SUB-MENU>======================
|Note:the operating device is CF Card
| <1> Download Application Program To SDRAM And Run
| <2> Update Main Application File
| <3> Update Backup Application File
| <4> Update Secure Application File
15
|
|
|
|
|