Cisco PIX 501 빠른 시작 매뉴얼 - 페이지 10

{카테고리_이름} Cisco PIX 501에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco PIX 501 21 페이지. Data sheet
Cisco PIX 501에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (20 페이지), 데이터시트 (8 페이지), 빠른 시작 매뉴얼 (20 페이지), 빠른 시작 매뉴얼 (18 페이지)

페이지 인쇄

Active Host Limitation

The PIX 501 supports up to 32 DHCP address leases with a 10-user license, up to 128 with an optional

50-user license, and 256 with an unlimited user license . A host is considered active when any of the

following statements are true:

• The host has passed traffic through the PIX Firewall during the time configured for the xlate

timeout interval

• The host has an established NAT/PAT translation through the PIX Firewall

• The host has an established TCP connection or UDP session through the PIX Firewall

• The host has an established user authentication through the PIX Firewall

Refer to the System Properties>Advanced>Timeouts online Help topic within PDM for the default

inactivity timeout values associated with each of the preceding bulleted items.

Restore the Default Configuration

You can restore your configuration back to the factory default values in one of the following ways:

• You can start the Startup Wizard at: https://192.168.1.1/startup.html

• Enter the following CLI commands:

Command

configure factory-default [inside

Step 1

ip address [address_mask]]

write memory

Step 2

If the optional inside IP address and address mask are specified, the factory-default configuration will

reflect the specified IP address.

The config factory-default command considers both licensing and platform in creating DHCP

Note

pool sizes of 32, 128, or 253 for the PIX 501. A user with an unlimited license can manually

change the IP address and netmask to increase the DHCP pool size to 256.

Entering the config factory-default command erases the current running configuration.

Caution

Description

Erases the running configuration and replaces it with

the factory default configuration.

Writes the factory default configuration to Flash

memory.