Cisco PIX 525 사용자 설명서 - 페이지 17

{카테고리_이름} Cisco PIX 525에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco PIX 525 30 페이지. Security appliance
Cisco PIX 525에 대해서도 마찬가지입니다: 데이터시트 (13 페이지)

Chapter 6

PIX 525

Fast Ethernet Circuit Board

The 4-port 64 bit/66 MHz FE card (PIX-4FE-66) is supported in software Versions 6.3, 6.2(2), 6.1(4),

and 5.2(9), and later versions. These are the minimum software versions that support the card.

Note

The PIX-4FE card continues to be supported but is no longer manufactured. The PIX-4FE and

PIX-4FE-66 cards are considered equivalent and interchangeable. You can install a PIX-4FE in the

primary unit and a PIX-4FE-66 in the secondary unit, as long as you install them in the same slot number

of each chassis. For example, if you install a PIX-4FE in Slot 1 of the primary unit, you must also install

a PIX-4FE-66 in Slot 1 of the secondary unit.

The new card has the following characteristics:

•

Figure 6-17 4-Port Circuit Board Overlap

Note

78-15170-02

Includes an Intel 21154BE bridge and four Intel 82559 Ethernet MAC/PHY devices.

Supports 10/100 mbps full/half-duplex operation on each port.

Retains bus performance when installed with other 66-MHz devices.

Does not support auto MDI/MDIX operation.

Port numbering is 2, 3, 4, 5 starting at the top, and continuing to the bottom, in consecutive order.

Installing a Circuit Board in the PIX 525

Overlap

Cisco PIX Security Appliance Hardware Installation Guide

6-17