Cisco Prisma EtherLinX 설치 지침 매뉴얼 - 페이지 11

{카테고리_이름} Cisco Prisma EtherLinX에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Prisma EtherLinX 38 페이지.

Important Safety Instructions,

Electromagnetic Compatibility Regulatory Requirements

This equipment meets applicable electromagnetic compatibility (EMC) regulatory

requirements. Refer to this equipment's data sheet for details about regulatory

compliance approvals. EMC performance is dependent upon the use of correctly

shielded cables of good quality for all external connections, except the power source,

when installing this equipment.

• Ensure compliance with cable/connector specifications and associated installation

instructions where given elsewhere in this manual.

Otherwise, comply with the following good practices:

• Multi-conductor cables should be of single-braided, shielded type and have

conductive connector bodies and backshells with cable clamps that are

conductively bonded to the backshell and capable of making 360° connection to

the cable shielding. Exceptions from this general rule will be clearly stated in the

connector description for the excepted connector in question.

• Ethernet cables should be of single-shielded or double-shielded type.

• Coaxial cables should be of the double-braided shielded type.

EMC

Where this equipment is subject to USA FCC and/or Industry Canada rules, the

following statements apply:

FCC Statement for Class A Equipment

This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference when this equipment is

operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residential

area is likely to cause harmful interference in which case users will be required to

correct the interference at their own expense.

4008226 Rev B

Continued

Continued on next page