Cisco Prisma EtherLinX 설치 지침 매뉴얼 - 페이지 33

{카테고리_이름} Cisco Prisma EtherLinX에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Prisma EtherLinX 38 페이지.

Device-Specific Configuration,

Using Telnet

Assign the Prisma EtherLinX unit an IP address BEFORE using a Telnet session.

Refer to Assigning IP Information earlier in this document. All configurations that

can be done via the serial port can also be performed using Telnet. Use only one

Telnet session at a time. Do not use an RS-232 serial session and a Telnet session at

the same time.

About DHCP

There is a DHCP client in the Prisma EtherLinX unit. By default, the DHCP client is

disabled. If a DHCP server is present on the network, the DHCP client initiates a

dialogue with the server during the boot up sequence. The server will then issue an

IP address, Default Gateway, and Subnet mask to the Prisma EtherLinX unit chassis.

Once the new IP address is received, the Prisma EtherLinX unit reboots so that the

new IP address takes effect. Refer to About Serial Port Configuration earlier in this

document for Enable/Disable information. If there is no DHCP server on the

network, use iConfig or serial configuration to manually set the IP addresses.

4008226 Rev B

Continued