Cisco RSP7000 설치 및 구성 매뉴얼 - 페이지 13

{카테고리_이름} Cisco RSP7000에 대한 설치 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco RSP7000 48 페이지. Upgrade kit in the cisco 7000 series routers
Cisco RSP7000에 대해서도 마찬가지입니다: 설치 (26 페이지)

페이지 인쇄

Using the EXEC Command Interpreter

Before you use the conﬁgure command, you must enter the privileged level of the EXEC command

interpreter with the enable command. The system prompts you for a password if one has been set.

The system prompt for the privileged level ends with a pound sign (#) instead of an angle bracket

(>). At the console terminal, enter the privileged level as follows:

Step 1

Step 2

Step 3

The pound sign (#) at the system prompt indicates that you are at the privileged level of the EXEC

command interpreter; you can now execute the EXEC-level commands that are described in the

following sections.

Using the Ping Command

Before you attempt to upload or retrieve a ﬁle from a remote host, ensure that the connection is good

between the router and the remote server. The packet internet groper (ping) program sends a series

of echo request packets to the remote device and waits for a reply. If the connection is good, the

remote device echoes them back to the local device.

The console terminal displays the results of each message sent: an exclamation point (!) indicates

that the local device received an echo, and a period (.) indicates that the server timed out while

awaiting the reply. If the connection between the two devices is good, the system will display a series

of exclamation points (! ! !) or [ok]. If the connection fails, the system will display a series of periods

( . . . ) or [timed out] or [failed].

To verify the connection between the router and a remote host, issue the ping command followed by

the name or Internet Protocol (IP) address of the remote server, then press Return. Although the

ping command supports conﬁgurable options, the defaults, including interface processor as the

protocol, are enabled when you enter a host name or address on the same line as the ping command.

For a description of the conﬁgurable options, refer to the appropriate software documentation.

The following example shows a successful ping:

Router# ping 1.1.1.1

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 12/12/12 ms

Router#

7000 Series Route Switch Processor (RSP7000) Installation and Configuration in the Cisco 7000 Series Routers

At the user-level EXEC prompt (>), enter the enable command. The EXEC command

interpreter prompts you for a privileged-level password, as follows:

Router> enable

Password:

Enter the password (the password is case sensitive). For security purposes, the password is

not displayed.

When you enter the correct password, the system displays the privileged-level system

prompt (#), as follows:

Router#

Installation Prerequisites