Cisco RSP7000 설치 및 구성 매뉴얼 - 페이지 18

{카테고리_이름} Cisco RSP7000에 대한 설치 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco RSP7000 48 페이지. Upgrade kit in the cisco 7000 series routers
Cisco RSP7000에 대해서도 마찬가지입니다: 설치 (26 페이지)

페이지 인쇄

Installation Procedures

The following sections describe the procedures for installing or replacing processor modules. Before

installing any new interfaces, ensure that your system meets the minimum software and microcode

requirements described in the sections "Software Prerequisites" and "Microcode Prerequisites" on

page 11.

Note

system power. However, you must shut down the system before removing or installing the RSP7000,

which is a required system component.

Caution

replacing an RSP7000. If you want to save the conﬁguration data in onboard NVRAM, then copy

the data to a server before you format the card; otherwise, the conﬁguration data will be lost. Refer

to the section "Saving and Retrieving the Conﬁguration File" on page 12.

Following the OIR overview, proceed to the section "Removing the RSP7000" for instructions on

removing the RSP7000, and then to the section "Replacing the RSP7000," on page 19, for the

installation instructions. After the new RSP7000 is secure, follow the procedures in the section

"Troubleshooting the Installation" on page 23 to verify that the new RSP7000 is installed and

functioning properly.

Removing the RSP7000

When you remove or install the RSP7000, be sure to use the ejector levers, which help to ensure that

the RSP7000 is fully inserted in the backplane or fully dislodged from it. Any RSP7000 or interface

processor that is only partially connected to the backplane can halt the system.

Figure 4 on page 20 shows a detail of the ejector lever mechanism in a vertical position that is

appropriate for the Cisco 7000; the Cisco 7010 slots are oriented horizontally.

When you simultaneously push the ejector levers inward (toward the carrier handle), the levers push

the RSP7000 into the slot and ensure that the board connectors are fully seated in the backplane.

Caution

required system component. Removing an RSP7000 while the system is operating will cause the

system to shut down or crash and might damage or destroy memory ﬁles.

Follow these steps to remove the RSP7000:

Step 1

Step 2

18 7000 Series Route Switch Processor (RSP7000) Installation and Conﬁguration in the Cisco 7000 Series Routers

The OIR feature allows you to remove and install interface processors without turning off

To avoid unnecessary errors, read the following OIR overview before removing or

You must shut down the system before removing or installing the RSP7000, which is a

Optional step: If you are replacing the RSP7000, upload (copy) the currently running

conﬁguration ﬁle to a TFTP server so you can retrieve it later. (See the section "Saving and

Retrieving the Conﬁguration File" on page 12.)

Slip on an antistatic strap and connect the equipment end of the strap to a captive

installation screw on an installed interface processor, or to any unﬁnished chassis surface.