Cisco RSP7000 설치 및 구성 매뉴얼 - 페이지 25

{카테고리_이름} Cisco RSP7000에 대한 설치 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco RSP7000 48 페이지. Upgrade kit in the cisco 7000 series routers
Cisco RSP7000에 대해서도 마찬가지입니다: 설치 (26 페이지)

페이지 인쇄

Interface Processor LEDs

Each interface processor contains an enabled LED. The enabled LED goes on to indicate that the

interface processor is operational and that it is powered up. It does not necessarily mean that the

interface ports on the interface processors are functional or enabled. When the boot sequence is

complete, all of the enabled LEDs should go on.

If any do not, one of the following errors is indicated:

•

The interface processor is not installed correctly (it is not fully seated in the backplane

connector).

•

The microcode and software that are loading at startup are not compatible.

•

The interface processor has failed.

System Startup Sequence

By checking the state of the LEDs, you can determine when and where the system failed in the

startup sequence. Because you turn on the system power with the on/off switches on each power

supply, it is easiest to observe the startup behavior from the rear of the chassis. Use the following

descriptions of the normal startup sequence to isolate the problem, then use the troubleshooting

procedures wherever the system fails to operate as expected. If you are able to isolate the problem

to a faulty hardware component, or if you are unable to successfully restart the system, refer to the

end of this document for instructions on contacting a service representative.

Note

and the amount of memory that must be initialized. During the system startup sequence, the time

required to initialize the memory (not necessarily the entire boot sequence) in a system that contains

128 MB of DRAM will be longer than in a system that contains 16 MB of DRAM.

During the boot sequence, the system banner display pauses while it initializes the memory. If your

router has more than 16 MB of DRAM, you may notice an increase in the amount of time required

to initialize the memory. The pause in the banner display occurs after the copyright line, and before

the system displays the list of installed hardware, as shown in the following display:

%SYS-5-RELOAD: Reload requested

System Bootstrap, Version 5.3(9)

[System initializes memory at this point in the display]

Note

correctly until you removed (or replaced) the RSP7000. If the following sequence indicates a new

problem with the power subsystem or one of the interface processors, refer to the Cisco 7000

Hardware Installation and Maintenance or Cisco 7010 Hardware Installation and Maintenance

publications for system startup troubleshooting procedures.

7000 Series Route Switch Processor (RSP7000) Installation and Configuration in the Cisco 7000 Series Routers

The time required for the system to initialize (boot) varies with different router conﬁgurations

The procedures in this section are based on the assumption that your system was operating

Troubleshooting the Installation