Cisco SCE 1000 and 빠른 시작 매뉴얼 - 페이지 22

{카테고리_이름} Cisco SCE 1000 and에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SCE 1000 and 49 페이지. Service control engine 1000 2xgbe

Step 2

Specify the IP address of the RDR-formatter destination.

Type the IP address of the RDR-formatter destination and press Enter.

Enter RDR-formatter destination's IP address:

Note that there is no default for this parameter.

Specify the TCP port number of the RDR-formatter destination.

Step 3

Type the TCP port number of the RDR-formatter destination and press Enter.

Note that there is no default for this parameter.

Enter RDR-formatter destination's TCP port number:

Example:

Following is a sample RDR-formatter configuration dialog, assigning the IP address and TCP port number.

Would you like to enter the RDR-formatter configuration menu? [no]: y

Enter RDR-formatter destination's IP address: 10.1.1.230

Enter RDR-formatter destination's TCP port number: 33000

Step 7: Configuring Access Control Lists (ACLs)

• Information About Access Control Lists, page 22

• Examples, page 25

• Configuring ACLs, page 22

• Entry Formats, page 23

• Order of Entries, page 23

Configuring ACLs

The SCE 1000 can be configured with Access Control Lists (ACLs), which are used to permit or deny incoming connections on

any of the management interfaces.

ACL #0 is a pre-defined list that permits access to all IP addresses.

Note

Configuration of access control lists is done in two stages:

1. Create the access control lists.

You may create 99 ACLs with a maximum of 20 entries per list. Each entry consists of an IP address, and an indication of

whether access is permitted or denied to this IP address.

2. Assign the ACLs to the appropriate management interface. (See )

The dialog permits you to skip the creation/editing of the ACLs and go directly to assigning ACLs to the management

interfaces.