Cisco SCE 1000 and 빠른 시작 매뉴얼 - 페이지 27
{카테고리_이름} Cisco SCE 1000 and에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SCE 1000 and 49 페이지. Service control engine 1000 2xgbe
페이지 인쇄
Detailed Steps
Enter the SNMP configuration menu.
Step 1
Would you like to enter the SNMP configuration menu? [no]: y
Type y and press Enter.
The SNMP configuration dialog begins.
Enable SNMP management.
Step 2
Type
and press Enter.
y
Enable SNMP management? [no]: y
If you choose to disable SNMP management, skip the rest of this section and go to Step 9: Configuring the
Topology-Dependent Parameters, page 29. The rest of the dialog is not presented, as it is irrelevant when SNMP
management is disabled.
Step 3
Configure the SNMP GET community.
a. Type the SNMP GET community name and press Enter.
The SNMP agent that resides inside the SCE 1000 will respond only to GET requests that use this community string.
Enter SNMP GET community name:
Note that there is no default for this parameter.
b. Assign an access list to restrict the SNMP management stations that may use this GET community.
Type a number (1 through 99) or type "0" to permit access to all IP addresses, and press Enter.
Enter Access list number allowing access with this community string, use '0' to allow all:
Configure additional GET communities.
Step 4
The maximum number of GET communities is 20.
a. To add more entries, do not accept the default:
Would you like to add another SNMP GET community? [no]:
Type y and press Enter.
b. Enter up to 20 SNMP GET communities as described in step 3.
c. When all entries have been added, accept the default:
Would you like to add another SNMP GET community? [no]:
Press Enter to accept.
Configure the SNMP SET community.
Step 5
a. Type the SNMP SET community name and press Enter.
The SNMP agent that resides inside the SCE 1000 will respond only to SET requests that use this community string.
Enter SNMP SET community name:
Note that there is no default for this parameter.
b. Assign an access list to restrict the SNMP management stations that may use this SET community.
Type a number (1 through 99) or type "0" to permit access to all IP addresses, and press Enter.
Enter Access list number allowing access with this community string, use '0' to allow all:
27