Cisco Secure Firewall 3120 시작하기 - 페이지 30

{카테고리_이름} Cisco Secure Firewall 3120에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Secure Firewall 3120 42 페이지.

페이지 인쇄

Configuration After Initial Setup

Setting

Management access through

data interfaces.

System time.

Smart license.

Inside interface IP address.

DHCP server for inside clients.

DHCP auto-configuration for

inside clients.

(Auto-configuration supplies

clients with addresses for WINS

and DNS servers.)

Getting Started

Configuration

A data interface management access list rule allows HTTPS access

through the inside interface. SSH connections are not allowed.

Both IPv4 and IPv6 connections are allowed.

Firepower 4100/9300: No data interfaces have default

management access rules.

ISA 3000: No data interfaces have default management access

rules.

FTDv: No data interfaces have default management access rules.

The time zone and NTP servers you selected.

Firepower 4100/9300: System time is inherited from the chassis.

ISA 3000: Cisco NTP servers: 0.sourcefire.pool.ntp.org,

1.sourcefire.pool.ntp.org, 2.sourcefire.pool.ntp.org.

Either registered with a base license, or the evaluation period

activated, whichever you selected.

Subscription licenses are not enabled. Go to the smart licensing

page to enable them.

192.168.95.1/24

Firepower 4100/9300: Data interfaces are not pre-configured.

ISA 3000: None. You must set the BVI1 IP address manually.

FTDv: 192.168.45.1/24

Running on the inside interface with the address pool 192.168.95.5

- 192.168.95.254.

Firepower 4100/9300: No DHCP server enabled.

ISA 3000: No DHCP server enabled.

FTDv: The address pool on the inside interface is 192.168.45.46

- 192.168.45.254.

Enabled on outside interface if you use DHCP to obtain the outside

interface IPv4 address.

If you use static addressing, DHCP auto-configuration is disabled.

Getting Started

Explicit, implied, or default

configuration

Implied.

Explicit.

Default.

Explicit, but indirectly.