Cisco Secure Firewall Management Center 2700 시작하기 매뉴얼 - 페이지 4

{카테고리_이름} Cisco Secure Firewall Management Center 2700에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Secure Firewall Management Center 2700 22 페이지.

Cable the Management Center

certain features such as configuring a proxy for HTTP communications, or using a Smart Software Satellite

Server for Smart Licensing.

Initial Network Configuration for Management Centers

• Management Interface

Note

• DNS Servers

Note

• NTP Servers

Cable the Management Center

You can cable the management center using one or more of the three connections listed below:

• Connect a keyboard to the USB port and a monitor to the VGA port of the management center. By default,

• Connect the management center CIMC port to a local network reachable from a local computer where

Cisco Secure Firewall Management Center 1700, 2700, and 4700 Getting Started Guide

By default, the management center seeks out a local DHCP server for the IP address, network mask, and

default gateway to use for the management interface (eth0). If the management center cannot reach a

DHCP server, it uses the default IPv4 address 192.168.45.45, netmask 255.255.255.0, and gateway

192.168.45.1. During the initial setup, you can accept these defaults or specify different values.

If you use DHCP, you must use DHCP reservation, so the assigned address does

not change. If the DHCP address changes, device registration will fail because

the management center network configuration gets out of sync. To recover from

a DHCP address change, connect to the management center (using the hostname

or the new IP address) and navigate to System ( ) > Configuration >

Management Interfaces to reset the network.

If you use IPv6 addressing for the management interface, you must configure the address using the web

interface after completing the initial setup.

Specify IP addresses for up to two DNS servers. If you use an evaluation license, you may choose not

to use DNS.

During initial configuration, you can also provide a hostname and domain to

facilitate communication between the management center and other hosts through

DNS; you can configure more domains after completing the initial setup.

Synchronize the system time on your management center and its managed devices during initial

configuration. You can accept the default (0.sourcefire.pool.ntp.org and 1.sourcefire.pool.ntp.org as the

primary and secondary NTP servers, respectively), or supply FQDNs or IP addresses for one or two

trusted NTP servers reachable from your network. If you do not use DNS, you cannot use FQDNs to

specify the NTP servers.

the management center sends console messages to the VGA port.

you can run an IPMI utility for Lights-Out Management. To use this connection see

Management, on page

17.

About the Secure Firewall Management Center 1700, 2700, and 4700

Set Up Light-Out