Cisco SNS 3715 하드웨어 설치 매뉴얼 - 페이지 27

{카테고리_이름} Cisco SNS 3715에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SNS 3715 42 페이지.

Installing the Appliance

Step 4

Slide the CMA tab that is at the end of the width-adjustment slider onto the end of the stationary slide rail that is attached

to the rack post. Slide the tab over the end of the rail until it clicks and locks.

Step 5

Open the hinged flap at the top of each plastic cable guide and route your cables through the cable guides as desired.

Reversing the Cable Management Arm (Optional)

Step 1

Rotate the entire CMA assembly 180 degrees, left-to-right. The plastic cable guides must remain pointing upward.

Step 2

Flip the tabs at the ends of the CMA arms so that they point toward the rear of the appliance.

Step 3

Pivot the tab that is at the end of the width-adjustment slider. Depress and hold the metal button on the outside of the tab

and pivot the tab 180 degrees so that it points toward the rear of the appliance.

Figure 11: Reversing the CMA

Note

CMA tab on end of width-adjustment

slider

This section describes how to connect to the system for initial setup.

Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide

Reversing the Cable Management Arm (Optional)

Metal button on outside of tab