Cisco SNS 3715 하드웨어 설치 매뉴얼 - 페이지 30

{카테고리_이름} Cisco SNS 3715에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SNS 3715 42 페이지.

페이지 인쇄

Setting Up the System With the Cisco IMC Configuration Utility

Wait for approximately two minutes to let the appliance boot to standby power during the first bootup. You can verify

system power status by looking at the system Power Status LED on the front panel. The system is in standby power mode

when the LED is amber.

Step 2

Plug your management Ethernet cable into the dedicated management port on the rear panel.

Step 3

Allow your preconfigured DHCP server to assign an IP address to the server node.

Step 4

Use the assigned IP address to access and log in to the Cisco IMC for the server node.

The default username for the server is admin. The default password is password.

Note

Step 5

From the Cisco IMC Server Summary window, click Launch KVM Console.

A separate KVM console window opens.

Step 6

From the Cisco IMC Summary window, click Power Cycle Server.

The system reboots.

Step 7

Select the KVM console window.

Note

The KVM console window must be the active window for the following keyboard actions to work.

Step 8

When prompted, press F8 to enter the Cisco IMC Configuration Utility.

When you open the Cisco IMC Configuration Utility for the first time, you are prompted to change the default

Note

password. The default password is password. The Strong Password feature is enabled.

The following are the requirements for strong password:

• The password can have a minimum of 8 characters and a maximum of 14 characters.

• The password must not contain the user's name.

• The password must contain characters from three of the following categories:

• English uppercase letters (A through Z)

• English lowercase letters (a through z)

• Base 10 digits (0 through 9)

• Non-alphabetic characters !, @, #, $, %, ^, &, *, -, _, =, "

Step 9

Continue with

Setting Up the System With the Cisco IMC Configuration Utility, on page

Setting Up the System With the Cisco IMC Configuration Utility

Before you begin

The following procedure is performed after you connect to the system and open the Cisco IMC Configuration

Utility.

Step 1

Set the NIC mode to choose which ports to use to access Cisco IMC for server management:

Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide

Installing the Appliance

26.