Cisco TelePresence MCU 4500 Series 시작하기 매뉴얼 - 페이지 4
{카테고리_이름} Cisco TelePresence MCU 4500 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence MCU 4500 Series 15 페이지. Multipoint control units
Cisco TelePresence MCU 4500 Series에 대해서도 마찬가지입니다: 시작하기 (18 페이지)
페이지 인쇄
Calling in to conferences
When you dial into a conference you can connect directly to your conference or into a
menu that presents you with a series of options (called an auto attendant). From the
auto attendant you can select the conference you want to join.
You can join a conference/auto attendant in three ways. Using a:
hardware video endpoint
software video endpoint
audio-only telephone
Dialing in using a hardware video endpoint
Your system administrator will provide you with a number that will either connect you
to the auto attendant or connect you directly to your conference. If there is a PIN you
will be prompted to enter it.
On all endpoints you must always press the pound/hash key (#) after
i
entering a conference PIN.
Dialing in using a software video endpoint
If you have a webcam and microphone you can dial into a conference using a software
video endpoint from your computer.
You can dial into a conference using one of two software video endpoints: Cisco
TelePresence Movi and Cisco TelePresence ConferenceMe.
Dialing into a conference using Movi
This guide assumes that Movi and/or ConferenceMe are already
i
installed. See the individual products documentation for information on
how to install Movi and/or ConferenceMe.
Your system adminstrator will provide you with an address to use with Movi. The
address will take the format <e164_number>@domain.name or,
<conference_name>@domain.com.
To join the conference using Movi, type the address into the address bar of Movi and
press Enter. To enter a PIN, click the keypad icon and enter the PIN followed by a '#'.
Press Enter.
Calling in to conferences
4