Cisco TelePresence Server 7010 교체 지침 매뉴얼 - 페이지 13
{카테고리_이름} Cisco TelePresence Server 7010에 대한 교체 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence Server 7010 18 페이지. 600w ac-input power supply and fan tray replacement
Cisco TelePresence Server 7010에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (23 페이지), 설치 지침 매뉴얼 (15 페이지), 설치 매뉴얼 (14 페이지), 시작하기 (16 페이지)
페이지 인쇄
Removing the Power Harness Cover, Power Harness, and Power Supply
Follow these steps to remove the power harness cover, power harness, and power supply:
Step 1
Note
chassis, this cover and power harness must be removed to access the power supply.
Step 2
Figure 8
Step 3
Step 4
Step 5
Step 6
Step 7
This completes the power supply removal procedure.
Proceed to the next section to install the new power supply and replace the power harness cover.
Follow Steps 1 and 2 in the section "Removing and Replacing the Chassis Cover Panel" on
page 9 to open the chassis.
The Cisco 7010 and Cisco 7505 have slightly different power harness covers, but for both
Use a number 1 Phillips screwdriver to remove the M3 screw that secures the power harness
cover to the backplane. (See Figure 8.)
Removing and Replacing the Power Harness Cover
Removing power harness cover
Holding the cover with one hand, tilt the top of the cover back toward you, then pull it up
slightly so that the tab clears the slot in the chassis floor.
When the tab clears the slot, pull the cover straight back off the harness and out of the
chassis.
Disconnect the power harness plug from the backplane receptacle by pulling the polarized
plug out of the receptacle; do not pull on the wires. (See Figure 9a.)
Use a number 2 Phillips screwdriver to remove the two M4 Phillips panhead screws that
secure the power supply ears (one on each side of the power supply) to the chassis frame.
(See Figure 9a.)
Using both hands, grasp both of the power supply handles and pull the power supply about
halfway out of the bay (see Figure 9b), then grab the sides of the supply and pull it out of
the chassis. (See Figure 9c.)
Power harness
cover
600W AC-Input Power Supply and Fan Tray Replacement Instructions
Replacing Components
13