Cisco UCS B200 M3 설치 매뉴얼 - 페이지 15

{카테고리_이름} Cisco UCS B200 M3에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B200 M3 34 페이지. Blade server
Cisco UCS B200 M3에 대해서도 마찬가지입니다: 설치 및 서비스 참고 사항 (36 페이지), 설치 및 서비스 참고 사항 (37 페이지), 매뉴얼 (8 페이지), 업그레이드 매뉴얼 (21 페이지), 설치 및 서비스 참고 사항 (28 페이지)

Server CIMC

Server BIOS

Cisco UCS Manager

Board controller firmware

Do one of the following actions:

• If your server's firmware and/or Cisco UCS Manager software are already at the required levels shown in the table above, you

can replace the CPU hardware by using the procedures in this section.

• If your server's firmware and/or Cisco UCS Manager software is earlier than the required levels, use the instructions in the

Cisco UCS B-Series Servers Upgrade Guide for Intel E5-2600 v2 Series CPUs

you upgrade, return to the procedures in this book to replace the CPU and heatsink hardware.

Removing a CPU and Heat Sink

You will use these procedures to move a CPU from one server to another, to replace a faulty CPU, or to upgrade from one CPU to

another.

The CPU pick and place tool is required to prevent damage to the connection pins between the motherboard

Note

and the CPU. Do not attempt this procedure without the required tool, which is included with each CPU

option kit.

Procedure

Step 1

Unscrew the four captive screws securing the heat sink to the motherboard. See callout 1.

Loosen one screw by a quarter turn, then move to the next in the X pattern shown in the following figure. Continue loosening

until the heat sink can be lifted off.

Step 2

Remove the heat sink (UCSB-HS-01-EP). See callout 2.

Remove the existing thermal compound from the bottom of the heat sink using the cleaning kit (UCSX-HSCK= ) included

with each CPU option kit. Follow the instructions on the two bottles of cleaning solvent.

2.1(3)

8.0

to upgrade your firmware and software. After