Cisco UCS X10c 설치 및 서비스 매뉴얼 - 페이지 14
{카테고리_이름} Cisco UCS X10c에 대한 설치 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS X10c 38 페이지. Front mezzanine gpu module
페이지 인쇄
Removing the Front Mezzanine GPU Module
The following additional equipment, which is not provided by Cisco, is required to install or remove the GPU
module.
• T8 Torx screwdriver
• #2 Phillips screwdriver
• Torque wrench
Removing the Front Mezzanine GPU Module
To remove an existing front mezzanine module, you will remove screws on the side of the compute node's
sheet metal tray and on the node's motherboard.
Caution
Use the following procedure to remove an existing front mezzanine module.
Before you begin
Review
The compute node cables must be disconnected, and the compute node must be removed from the chassis to
perform this task.
Step 1
Remove the top cover of the compute node.
Removing a Compute Node Cover, on page
Step 2
Remove the screws.
a) Using a T8 Torx screwdriver, remove the four T8 Flathead screws, two screws per side.
b) Using a #2 Phillips screwdriver, loosen the two #2 Phillips captive screws at the rear of the front mezzanine module.
Cisco UCS X10c Front Mezzanine GPU Module Installation and Service Guide
6
Do not operate the compute node without a front mezzanine module installed.
Cabling Considerations, on page 12
for important information before beginning this task.
11.
Installing the GPU Module