Cisco Versatile Interface Processor (VIP6-80) (VIP6-80) 설치 및 구성 매뉴얼 - 페이지 34
{카테고리_이름} Cisco Versatile Interface Processor (VIP6-80) (VIP6-80)에 대한 설치 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Versatile Interface Processor (VIP6-80) (VIP6-80) 40 페이지. Versatile interface processor
페이지 인쇄
Removing SDRAM DIMMs
Use the following procedure to remove the existing DIMMs:
Step 1
Turn off the system power and remove the VIP6-80 from the system. (Follow the steps in the
a VIP6-80" section on page
Step 2
Place the VIP6-80 on an antistatic mat or pad and ensure that you are wearing an antistatic device, such
as a wrist strap.
Step 3
Position the VIP6-80 so that the handles are away from you and the bus connectors are toward
you—opposite of the position shown in
Locate the DIMM and position the VIP6-80 so that you are facing the DIMM module you want to
Step 4
remove.
Open the DIMM socket tabs on the DIMM to release the DIMM from the socket. (See
Step 5
DIMM is under tension in the socket; therefore, the DIMM might be released from the socket with some
force.
Figure 9
With the DIMM socket tabs open, grasp the ends of the DIMM between your thumbs and forefingers and
Step 6
pull the DIMM completely out of the socket. (See
Figure 10
Place a removed DIMM on an antistatic mat, and store it in an antistatic container to protect it from ESD
Step 7
damage.
Versatile Interface Processor (VIP6-80) Installation and Configuration Guide
34
18.)
Opening the DIMM Socket Tabs
Removing the DIMM
Polarization notch
Figure
2.
Pull the tabs away with
your thumbs, bracing your
forefingers against the
DIMM socket sides
SDRAM DIMM
Figure
10.)
Metal fingers
"Removing
Figure
9.) The
OL-5078-01