Epson 2450 - Perfection Photo Scanner 제품 정보 - 페이지 3

{카테고리_이름} Epson 2450 - Perfection Photo Scanner에 대한 제품 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 2450 - Perfection Photo Scanner 5 페이지. Product support bulletin(s)
Epson 2450 - Perfection Photo Scanner에 대해서도 마찬가지입니다: 사용자 설명서 (7 페이지), 제품 지원 게시판 (34 페이지), 여기에서 시작 (2 페이지), 사양 (2 페이지), 매뉴얼 (11 페이지), 제품 지원 게시판 (40 페이지), 제품 지원 게시판 (17 페이지), 적합성 선언 (2 페이지), 제품 지원 게시판 (14 페이지), 제품 지원 게시판 (18 페이지), 제품 지원 게시판 (36 페이지)

Scanning Transparencies and Film

Before scanning transparent documents, you need to remove

the scanner's reflective document mat; this exposes the scanner's

transparency unit (light source), which is built into the lid.

If you're scanning slides or film strips, you'll also need to use

one of the film holders.

To use the transparency unit, remove the reflective document

mat by grasping the top of the mat and sliding it up gently, as

shown.

remove mat

by sliding it up

Make sure the cable for the tranparency unit is plugged into the

round connector. If not, turn off the scanner, then connect the

cable as shown.

Using Film Holders

Film has two sides, a shiny base side and a dull emulsion side.

The base side of the film has the film maker's name and film ID

numbers printed on it. Always place the shiny base side down.

To scan 35-mm film strips, 4 × 5-inch film, or 120/220 (6 × 9-

cm) film, place the film in the correct holder, as shown:

transparency unit

Place the holder with the film onto the scanner. Make sure the

white triangle on the holder points to the upper-right corner of

the scanner.

9/01

EPSON Perfection 2450 PHOTO

35-mm strips

4 × 5-inch film

EPSON Perfection 2450 PHOTO - 3

120/220 (6 × 9-cm)

film