Cisco WS-C6509 사용자 설명서 - 페이지 7

{카테고리_이름} Cisco WS-C6509에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WS-C6509 28 페이지. Catalyst 6500 series
Cisco WS-C6509에 대해서도 마찬가지입니다: 업그레이드 매뉴얼 (24 페이지), 데이터시트 (30 페이지)

페이지 인쇄

1. Catalyst 6509 Switch and Cisco 7606 and Cisco 7609 Routers

The cryptographic boundary does not include the network module or service module itself unless it

performs approved cryptographic functions. In other words, the cryptographic boundary encompasses

all hardware components within the chassis except any installed nonapproved cryptographic network

modules or service modules and the power supply submodules. Service modules that are currently

available include the Network Access Module (NAM), a Firewall Services Module, and a VPN Services

Module. All of the functionality described in this publication is provided by components within this

cryptographic boundary.

The service modules require that a special opacity shield be installed over the intake-side air vents in

order to operate in FIPS-approved mode. The shield decreases the surface area of the vent holes,

reducing visibility within the cryptographic boundary to FIPS-approved specifications. Detailed

installation instructions for the shield are provided in this publication.

The Catalyst 6509 switch and the Cisco 7606 and Cisco 7609 routers incorporate a single VPN Services

Module cryptographic accelerator card. The VPN Services Module is installed in a chassis module slot.

Cisco IOS features such as tunneling, data encryption, and termination of remote access WANs using

IPsec, Layer 2 forwarding and Layer 2 tunneling protocols make the Catalyst 6509 switch and the

Cisco 7606 and Cisco 7609 routers with VPN Services Module an ideal platform for building virtual

private networks or outsourced dial solutions. The RISC-based processor provides the power needed for

the dynamic requirements of the remote branch office.

Module Interfaces

The switch and router chassis physical interfaces are located on the supervisor engine front panel. (See

Figure

Figure 4

CONSOLE port

WS-X6K-SUP2-2GE

SUPERVISOR2

Status

LEDs

The Catalyst 6509 switch and the Cisco 7606 and Cisco 7609 routers provide console ports, fixed

Ethernet interfaces, nine network and service module slots on the Catalyst 6509 switch and Cisco 7609

router chassis, and six network and service module slots on the Cisco 7606 router chassis. Network

modules support a variety of LAN and WAN connectivity interfaces, such as the following: Ethernet,

ATM, serial, ISDN BRI, and integrated CSU/DSU options for primary and backup WAN connectivity.

An network module or a service module is installed in one of the chassis slots, which are located on the

front panel of the chassis. The modules interface directly with the supervisor engine, and cannot perform

cryptographic functions; they only serve as a data input and data output physical interface.

The supervisor engine has two Ethernet uplink ports. The supervisor engine also has an RJ-45 connector

for a console terminal for local system access. The Ethernet ports have LINK LEDs. Power is supplied

to the module from the power supply through the backplane.

Catalyst 6509 switch and the Cisco 7606 and Cisco 7609 routers.

OL-6334-01

4.)

Supervisor Engine Physical Interfaces

PCMCIA LED

CONSOLE

PORT

MODE

CONSOLE

CONSOLE PORT

PCMCIA slot

MODE switch

RESET button

Catalyst 6509 Switch, Cisco 7606 Router, and Cisco 7609 Router with VPN Services Module Certification Note

Catalyst 6509/Cisco 7606/Cisco 7609 Cryptographic Module

Switch load

display

Switch

Load

100%

PCMCIA

EJECT

1000BASE-X GBIC

Uplink Ports

PORT 1

PORT 2

LINK LEDs

Figure 4

shows the LEDs located on the

Table 1

describes the LEDs.