Cisco 2000 시작하기 매뉴얼 - 페이지 6

{카테고리_이름} Cisco 2000에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2000 31 페이지.

페이지 인쇄

Enter the netmask for the interface's IP address or press Enter to accept the current value. For example:

255.255.255.0

The following prompt (appended with the current value) appears:

Management gateway?

Enter the gateway for the interface's IP address or press Enter to accept the current value. For example:

10.2.1.1

The following prompt appears:

Are these settings correct: (y or n)?

If the settings are correct, type y and press Enter to accept the settings and continue.

If the settings are incorrect, type n and press Enter. You are prompted to enter the information again.

After you have accepted the settings, log out of the shell.

What to Do Next



Complete the setup process using the procedures in

Initial Setup Page: Management Centers

For all Management Centers, you must complete the setup process by logging into the Management Center's web

interface and specifying initial configuration options on a setup page. You must change the administrator

password, specify network settings if you haven't already, and accept the EULA.

The setup process also allows you to register and license devices. Before you can register a device, you must

complete the setup process on the device itself, as well as add the Management Center as a remote manager, or

the registration will fail.

Procedure

Direct your browser to

management interface:

—

For a Management Center connected to a computer with an Ethernet cable, direct the browser on that

computer to the default management interface IPv4 address:

—

For a Management Center where network settings are already configured, use a computer on your

management network to browse to the IP address of the Management Center's management interface.

admin

See the following sections for information on completing the setup:

—

Change Password, page 7

—

Network Settings, page 7

—

Time Settings, page 7

—

Recurring Rule Update Imports, page 8

—

Recurring Geolocation Updates, page 8

—

Automatic Backups, page 8

—

License Settings, page 8

—

Device Registration, page 9

Cisco Firepower Management Center Getting Started Guide

, where

https://mgmt_ip/

as the username and

Admin123

Installing the Firepower Management Center

Initial Setup Page: Management Centers, page

is the IP address of the Management Center's

mgmt_ip

https://192.168.45.45/

as the password.