Cisco 2500 Series 구성 매뉴얼 - 페이지 14

{카테고리_이름} Cisco 2500 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2500 Series 19 페이지. Wireless controller
Cisco 2500 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 배포 매뉴얼 (23 페이지), 구성 매뉴얼 (50 페이지), 시작하기 매뉴얼 (47 페이지)

페이지 인쇄

1. Configuring the Global Parameters

Configuring the Access Server

Step 6

Configuring the Ethernet or Token Ring Interfaces

Take the following steps to configure the Ethernet or Token Ring interface to allow

communication over a LAN. To configure the interface parameters, you need to know your

Ethernet or Token Ring interface network addresses.

Step 1

Step 2

4-14 Cisco 2500 Series Access Server User Guide

Enter yes if you will be using IPX on your asynchronous lines, In this example,

the access server will not be using IPX on the asynchronous lines:

Configure XRemote font servers? [no]:

Configure for Async IPX? [yes]: no

In the following example, the system is being configured for an Ethernet LAN

using IP. Respond as follows (using your own addresses and mask) to the setup

prompts:

Configuring interface parameters:

Configuring interface Ethernet0:

Is this interface in use? [yes]:

Configure IP on this interface? [yes]:

IP address for this interface: 172.16.72.1

Number of bits in subnet field [0]: 8

Class B network is 172.16.0.0, 8 subnet bits; mask is 255.255.255.0

Enter yes if you will be using AppleTalk on the interface, enter yes to configure

for extended AppleTalk networks, and then enter the cable range number. See the

appendix "Internetworking Primer" for additional information on AppleTalk

routing. Enter the zone name, and any other additional zones that will be

associated with your local zone:

Configure AppleTalk on this interface? [no]: yes

Extended AppleTalk network? [no]: yes

AppleTalk starting cable range [0]: 1

AppleTalk ending cable range [1]: 2

AppleTalk zone name [myzone]:

AppleTalk additional zone name: otherzone

AppleTalk additional zone name: