Cisco 2501 - Router - EN 구성 매뉴얼 - 페이지 15
{카테고리_이름} Cisco 2501 - Router - EN에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2501 - Router - EN 19 페이지. Access server - chapter 4
Cisco 2501 - Router - EN에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지)
페이지 인쇄
Step 3
Configuring the Synchronous Serial Interfaces
The synchronous serial interfaces are configured to allow connection to WANs through a
CSU/DSU. Once the Ethernet or Token Ring port on your access server has been
configured, take the following steps to configure the serial port:
Step 1
Step 2
Step 3
Determine if you are going to enable IPX on this interface, enter the unique IPX
network number. See the appendix "Internetworking Primer" for additional
information on IPX routing:
Configure IPX on this interface? [no]: yes
IPX network number [1]: B001
Configure XNS on this interface? [no]
Enter yes to configure serial port 0:
Configuring interface Serial0:
Is this interface in use? [no]: yes
Determine what protocols you will allow on the synchronous serial interface and
enter the appropriate responses:
Configure IP unnumbered on this interface? [no]: no
IP address for this interface: 172.16.73.1
Number of bits in subnet field [8]:
Class B network is 172.16.0.0, 8 subnet bits; mask is 255.255.255.0
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [yes]:
AppleTalk starting cable range [2]: 3
AppleTalk ending cable range [3]: 3
AppleTalk zone name [myzone]: ZZ Serial
AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes
IPX network number [2]: B000
Configure the second synchronous serial interface as follows:
Configuring interface Serial1:
Is this interface in use? [no]:
Configuring the Cisco 2500 Series Access Server 4-15
Configuring the Access Server