Cisco 2600 Series 설치 매뉴얼 - 페이지 7

{카테고리_이름} Cisco 2600 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2600 Series 12 페이지. Configuring adsl wic to support pppoe clients
Cisco 2600 Series에 대해서도 마찬가지입니다: 릴리스 정보 (32 페이지), 구성 (15 페이지), 애플리케이션 노트 (41 페이지), 데이터시트 (6 페이지), 부록 (15 페이지), 설치 매뉴얼 (22 페이지), 개요 (13 페이지), 빠른 시작 매뉴얼 (2 페이지), 매뉴얼 (5 페이지)

페이지 인쇄

1. Removing the Cover

Removing the Power Supply

This section describes how to remove the internal power supply. Although the AC power supply is

shown in the illustrations that follow, the procedure is the same for removing both the AC and DC

power supplies.

Take these steps to remove the power supply:

Step 1

Figure 4

Step 2

Figure 5

Screw

Locate the six-pin connector on the system board near the front of the router, and

disconnect it. (See Figure 4.)

If cable tie-wraps on the harness interfere with removing the connectors, cut the

Note

tie-wraps, being careful not to cut the power supply wires.

Locating the Connectors

Fan

Power connector

Fan connector

Remove the mounting screw that secures the power supply to the chassis. (See Figure 5.)

Set aside this screw for later use.

Removing the Mounting Screw

Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers

Removing the Power Supply

AC power supply