Cisco 5100 설치 준비 - 페이지 2

{카테고리_이름} Cisco 5100에 대한 설치 준비을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 5100 6 페이지. Enterprise network compute system
Cisco 5100에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (32 페이지)

페이지 인쇄

Safety with Electricity

Always follow these electrostatic discharge (ESD) prevention procedures when removing and replacing

modules:

• Ensure that the chassis is electrically connected to ground.

• Wear an ESD-preventive wrist strap, ensuring that it makes good skin contact. Connect the clip to an

• If no wrist strap is available, ground yourself by touching a metal part of the chassis.

Note

For the safety of your equipment, periodically check the resistance value of the anti-static strap. It should be

between 1 and 10 megohms (Mohm).

Safety with Electricity

Follow these general guidelines when working on equipment that is powered by electricity:

• Locate the emergency power-off switch in the room in which you are working. If an electrical accident

• Disconnect all power before doing the following:

• Look carefully for possible hazards in your work area, such as moist floors, ungrounded power extension

• Do not work alone if hazardous conditions exist.

• Never assume that power is disconnected from a circuit. Always check.

• Never open the enclosure of the internal power supply.

• If an electrical accident occurs, proceed as follows:

Follow these guidelines when working with any equipment that is disconnected from a power source but is

still connected to telephone wiring or other network cabling:

• Never install telephone wiring during a lightning storm.

• Never install telephone jacks in wet locations unless the jack is specifically designed for it.

Preparing for Installation

unpainted surface of the chassis frame to channel unwanted ESD voltages safely to ground. To guard

against ESD damage and shocks, the wrist strap and cord must operate effectively.

occurs, you can quickly turn off the power.

• Installing or removing a chassis.

• Working near power supplies.

cables, frayed power cords, and missing safety grounds.

• Turn off power to the device.

• Call for help.

• Determine if the person needs rescue breathing or external cardiac compressions; then take appropriate

action.

Preparing for Installation