Cisco 7513 Series 빠른 시작 매뉴얼 - 페이지 27

{카테고리_이름} Cisco 7513 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7513 Series 44 페이지. Chassis replacement
Cisco 7513 Series에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (26 페이지), 데이터시트 (11 페이지), 매뉴얼 (30 페이지), 유지 관리 (20 페이지), 교체 지침 매뉴얼 (19 페이지), 교체 지침 매뉴얼 (22 페이지)

페이지 인쇄
Cisco 7513 Series 빠른 시작 매뉴얼
Install Field Replaceable Units (FRUs)
Make a Flash Memory Card Image Bootable
Note
In this example, the filename is new.image,
and the Flash memory card is located in slot 0.
Step 1
Enter the configure terminal command at
the enable prompt, as follows:
Router# configure terminal
Step 2
Enter the no boot system command, as
follows.
Router(config)# no boot system
Step 3
Enter the boot system flash
slot0:new.image command, as follows:
Router(config)# boot system flash
slot0:new.image
Step 4
Enter the config-register 0x2102
command to enable loading an image
from Flash memory:
Router(config)# config-register 0x2102
Step 5
Press Ctrl-Z to exit configuration mode.
Step 6
Enter the copy running-config
startup-config command to save the
configuration to NVRAM as follows:
Hostname# copy running-config startup-config
Step 7
Enter the reload command. When the
system reloads, it will boot the image
new.image from the Flash memory card in
slot 0.
Router# reload
Enable Booting from Flash
Memory
To enable booting from Flash memory, set
configuration register bits 3, 2, 1, and 0 to a value
between 2 and 15 in conjunction with the boot
system flash device:filename configuration
command, where device is bootflash:, slot0:, or
slot1:, and filename is the name of the file from
which you want to boot the system. In the following
example, the Flash memory card is in slot 0.
Step 1
Enter the configure terminal command at
the enable prompt, as follows:
Router# configure terminal
Step 2
At the prompt, enter configuration
commands, one per line.
Enter configuration commands, one per line.
Step 3
Press Ctrl-Z to exit configuration.
Step 4
Enter the boot system flash
bootflash:slot0: filename command, as
follows:
Router(config)# boot system flash
blootflash:slot0: filename
Step 5
Enter the config-register command with
the value shown in the following example:
Router(config)# config-reg 0x0102
Ctrl-Z
Router#
Press Ctrl-Z to exit enable booting mode.
25