Cisco 7513 Series 빠른 시작 매뉴얼 - 페이지 34

{카테고리_이름} Cisco 7513 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7513 Series 44 페이지. Chassis replacement
Cisco 7513 Series에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (26 페이지), 데이터시트 (11 페이지), 매뉴얼 (30 페이지), 유지 관리 (20 페이지), 교체 지침 매뉴얼 (19 페이지), 교체 지침 매뉴얼 (22 페이지)

페이지 인쇄

Install Field Replaceable Units (FRUs)

Step 7

Enter the name of the conﬁguration ﬁle.

The default is to use the name of the

router with the sufﬁx -confg. Press Return

to accept the default ﬁlename, or enter a

different name for the ﬁle, then press

Return. In the following example, the

default is accepted:

Name of configuration file to write

[Router-confg]?

Write file Router-confg on host 1.1.1.1?

[confirm]

Writing Router-confg .....

Step 8

The system displays the instructions you

entered for conﬁrmation. If the

instructions are not correct, enter n (no),

and then press Return to cancel the

process. To accept the instructions, press

Return, or press y and then press Return.

In the following example, the default is

accepted:

Write file Router-confg on host 1.1.1.1?

[confirm]

Writing Router-confg: !!!! [ok]

The system displays a series of exclamation points

(! ! !) or periods (. . .) during the copy process. The

!!!! and [ok] indicate that the operation was

successful. A series of periods (...) and [timed out] or

[failed] indicates a failure of the process.

If the display indicates that the process was

successful, the copy process is complete. The

conﬁguration is stored on the remote ﬁle server.

If the display indicates that the process failed, the

conﬁguration was not saved (see the following

example):

Writing Router-confg .....

Repeat the preceding steps, or select a different

remote ﬁle server and repeat the preceding steps.

After you upload the conﬁguration ﬁle, continue

with the "Remove and Install an Interface Processor,

Filler, VIP, or RSP" section on page 27 to install the

RSP. If you are unable to copy the conﬁguration to a

remote host successfully, contact your network

administrator or contact Cisco technical assistance.