Cisco 7513 Series 매뉴얼 - 페이지 15

{카테고리_이름} Cisco 7513 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7513 Series 30 페이지. Chassis replacement
Cisco 7513 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (44 페이지), 교체 지침 매뉴얼 (26 페이지), 데이터시트 (11 페이지), 유지 관리 (20 페이지), 교체 지침 매뉴얼 (19 페이지), 교체 지침 매뉴얼 (22 페이지)

Figure 6

This completes the chassis removal procedure.

If you have not yet installed the new chassis in the rack, proceed to the next section.

Installing the New Chassis in the Rack

Mount the chassis in the rack before connecting any interface or power cables. If possible, install the

new, empty chassis in the rack ﬁrst, and then install the system components from the old chassis. To

mount the chassis, install the ears on the chassis ﬁrst, place the chassis in the rack, and then secure

the ears to the rack rails.

We recommend that two people perform this procedure. Before lifting the chassis, ensure that your

path to the rack is unobstructed.

To install the chassis in the rack, follow these steps:

Step 1

Step 2

Step 3

Lifting the Chassis

POWER

Two people are required to perform this step. With a person positioned at either side of

the chassis, grasp the bottom edge of the chassis with one hand near the front and the

handle on the side of the chassis with the other, as shown in Figure 6.

Grasping the chassis as shown in Figure 6, slowly lift the chassis in unison. To prevent

injury, avoid sudden twists or moves.

With the chassis positioned so the front is closest to the rack, insert the front of the chassis

into the rack between the brackets, and then slowly lower the chassis until it rests on the

two bracket ledges. (See Figure 7.)

Cisco 7513 and Cisco 7576 Chassis Replacement and Upgrade Instructions

Replacing a Rack-Mounted Chassis

POWER