Cisco Aironet 1500 Series 시작하기 매뉴얼 - 페이지 4

{카테고리_이름} Cisco Aironet 1500 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1500 Series 31 페이지. Lightweight outdoor mesh access points
Cisco Aironet 1500 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지)

페이지 인쇄

Management Center Initial Setup

After you deploy and install a Firepower Management Center, you must complete a setup process that allows the

new appliance to communicate on your trusted management network. You must also change the administrator

password and accept the end user license agreement (EULA).

The setup process also allows you to perform many initial administrative-level tasks, such as setting the time,

registering and licensing devices, and scheduling updates. The options you choose during setup and registration

determine the default interfaces, inline sets, zones, and policies that the system creates and applies to managed

devices.

Before you begin the setup, make sure that you can meet the following conditions:

Access

To set up a new appliance, you must connect using either keyboard and monitor/KVM (keyboard, video, and

mouse) or a direct Ethernet connection to the appliance's management interface. After initial setup, you can

configure the appliance for serial access. For more information, see the Cisco Firepower Management Center

750, 1500, 2000, 3500, and 4000 Hardware Installation Guide.

Note:

Do not use a KVM console with USB mass storage to access the appliance for the initial setup because

the appliance may attempt to use the mass storage device as a boot device.

Network and Deployment Information

You have, at minimum, the information needed to allow the appliance to communicate on your management

network: an IPv4 or IPv6 management IP address, a netmask or prefix length, and a default gateway.

If you know how the appliance is deployed, the setup process is also a good time to perform many initial

administrative-level tasks, including registration and licensing.

Note:

If you are deploying multiple appliances, set up your devices first, then their managing Firepower

Management Center. The initial setup process for a device allows you to preregister it to a Management

Center; the setup process for a Management Center allows you to add and license preregistered managed

devices.

After you complete setup, you will use the Firepower Management Center's web interface to perform most

management and analysis tasks for your deployment. Note that Firepower devices have a restricted web interface

that you can use only to perform basic administration. For more information, see

Note:

If you are setting up an appliance after restoring it to factory defaults (see

Management Center to Factory Defaults, page

settings, you can use a computer on your management network to browse directly to the appliance's web interface

to perform the setup. Skip to

The following diagram illustrates the choices you can make when setting up Management Centers:

Procedure

Mount the appliance in your rack using the mounting kit and its supplied instructions.

Attach the power cord to the appliance and plug into a power source.

Cisco Firepower Management Center Getting Started Guide

12) and you did not delete the appliance's license and network

Initial Setup Page: Management Centers, page

Installing the Firepower Management Center

Next Steps, page

Restoring a Firepower

10.