Cisco Aironet 1500 Series 시작하기 매뉴얼 - 페이지 9

{카테고리_이름} Cisco Aironet 1500 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1500 Series 31 페이지. Lightweight outdoor mesh access points
Cisco Aironet 1500 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지)

페이지 인쇄

Procedure

Obtain the License Key for your chassis during the initial setup from the License Settings section of the initial

setup page.

The License Key is clearly labeled; for example, 66:18:E7:6E:D9:93:35.

Note:

You can find the License Key on a Firepower Management Center at any time when you click the Add

New License button from the System>Licenses>Classic Licenses page.

To obtain your license, navigate to

license key (66:18:E7:6E:D9:93:35) and the Product Authorization Key (PAK).

Note:

If you ordered additional licenses, you can enter the PAKs separated commas for those licenses at the

same time.

Follow the on-screen instructions to generate a license or licenses, which will be emailed to you.

Paste the license or licenses in the validation box click Add/Verify.

What to Do Next



Continue with initial setup.

Note:

If you have devices that use Cisco Smart Licensing, you use the System>Licenses>Smart Licenses page

to add and verify licenses. Refer to the product documentation for those devices for information on how to add

Smart Licenses to the Firepower Management Center. The Firepower Management Center Configuration Guide

provides more information about Classic Licenses and Smart Licenses, the types of licenses for each class, and

how to manage the licenses across your deployment.

Device Registration

A Firepower Management Center can manage any device, physical or virtual, currently supported by the Firepower

System.

You must configure remote management on the device before you can register the device to a Management

Center.

If you are using Firepower System Version 6.0 or greater, see the device management information in the Firepower

Management Center Configuration Guide for instructions on registering your devices.

If you are using a Firepower System Version previous to 6.0, you can add most pre-registered devices to the

Management Center during the initial setup process. However, if a device and the Management Center are

separated by a NAT device, you must add it after the setup process completes; see the Firepower 7000 and 8000

Series Installation Guide.

You must configure both traffic channels to use the same management interface when you use a non-default

management interface to connect your Management Center and managed device and those appliances are

separated by a NAT device. See "Deploying on a Management Network" in the Firepower 7000 and 8000 Series

Installation Guide for more information.

When you register a managed device to a Management Center, leave the

box enabled if you want to automatically apply access control policies to devices upon registration. Note that you

cannot choose which policy the Management Center applies to each device, only whether to apply them. The

policy that is applied to each device depends on the detection mode (see Setting Up Firepower Managed Devices

in the Firepower 7000 and 8000 Series Installation Guide) you chose when configuring the device, as listed in the

following table.

Cisco Firepower Management Center Getting Started Guide

https://www.cisco.com/go/license/

Installing the Firepower Management Center

where you will be prompted for the

Apply Default Access Control Policies

check