Cisco Aironet 3500 Series 시작하기 매뉴얼 - 페이지 9
{카테고리_이름} Cisco Aironet 3500 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 3500 Series 35 페이지. Aironet 3500 series lightweight access point
Cisco Aironet 3500 Series에 대해서도 마찬가지입니다: 온라인 도움말 매뉴얼 (8 페이지), 데이터시트 (6 페이지), 시작하기 매뉴얼 (31 페이지)
페이지 인쇄
You can mount the access point above a suspended ceiling but you must purchase
Note
additional mounting hardware: See "Mounting the Access Point" section on page 13 for
additional information.
• Access point power options: power supplied by the recommended external power supply (Cisco
AIR-PWR-B), a DC power supply, PoE from a network device, or a PoE power injector/hub
(usually located in a wiring closet).
Note
Access points mounted in a building's environmental airspace must be powered using PoE
to comply with safety regulations.
Cisco recommends that you make a site map showing access point locations so that you can record the
device MAC addresses from each location and return them to the person who is planning or managing
your wireless network.
Installation Summary
Installing the access point involves these operations:
• Performing a pre-installation configuration (optional)
• Mounting the access point
• Grounding the access point
• Deploying the access point on the wireless network
Performing a Pre-Installation Configuration
The following procedures ensure that your access point installation and initial operation go as
expected. A pre-installation configuration is also known as priming the access point. This procedure
is optional.
Performing a pre-installation configuration is an optional procedure. If your network
Note
controller is properly configured, you can install your access point in its final location and
connect it to the network from there. See the "Deploying the Access Point on the Wireless
Network" section on page 13 for details.
9