Cisco Aironet 3500 Series 시작하기 매뉴얼 - 페이지 5

{카테고리_이름} Cisco Aironet 3500 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 3500 Series 31 페이지. Aironet 3500 series lightweight access point
Cisco Aironet 3500 Series에 대해서도 마찬가지입니다: 온라인 도움말 매뉴얼 (8 페이지), 데이터시트 (6 페이지), 시작하기 매뉴얼 (35 페이지)

페이지 인쇄
Cisco Aironet 3500 Series 시작하기 매뉴얼
If your appliance has redundant power supplies, attach power cords to both power supplies and plug them
into separate power sources.
3.
Turn on the appliance.
What to Do Next
If you are connecting a computer directly to the appliance's physical management interface to set up the
appliance, continue to
If you are using a keyboard and monitor to set up the appliance, continue to
a Keyboard and Monitor (KVM), page

Management Center Setup Using the Management Interface

Procedure
1.
Using the supplied Ethernet cable, connect the network interface on the preconfigured computer directly to
the management interface on the appliance.
Confirm that the link LED is on for both the network interface on the local computer and the management
interface on the appliance.
2.
Use a web browser to navigate to the appliance's default IP address:
https:// 192.168.45.45
The login page appears.
3.
Log in using
admin
What to Do Next
Complete the setup process using the procedures in

Management Center Setup Using a Keyboard and Monitor (KVM)

Procedure
1.
Using the supplied Ethernet cable, connect the management interface on the back of the appliance to a
protected management network.
2.
Connect the monitor to the VGA port and the keyboard to one of the USB ports.
3.
Log into the command line interface using
the password is case-sensitive.
4.
Run the following script:
sudo /usr/local/sf/bin/configure-network
The following prompt (appended with the current value) appears:
Management IP address?
5.
Enter the IP address you want to assign to the management interface or press Enter to accept the current
value. For example:
10.2.2.20
The following prompt (appended with the current value) appears:
Management netmask?
Cisco Firepower Management Center Getting Started Guide
Management Center Setup Using the Management Interface, page
5.
as the username and
Admin123
admin
Installing the Firepower Management Center
as the password.
Initial Setup Page: Management Centers, page
as the username and
Admin123
5.
Management Center Setup Using
as the password. Note that
6.
5