Cisco APIC L4 설치 및 서비스 매뉴얼 - 페이지 37

{카테고리_이름} Cisco APIC L4에 대한 설치 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco APIC L4 46 페이지.

Installing the Server

Note

• The front-panel KVM connector has been designed to switch the USB port between Host OS and BMC.

• Smart Access USB can be enabled or disabled using any of the BMC user interfaces. For example, you

can use the Cisco IMC Configuration Utility that is accessed by pressing F8 when prompted during

bootup.

• In a case where no management network is available to connect remotely to Cisco IMC, a Device Firmware

Update (DFU) shell over serial cable can be used to generate and download technical support files to the

USB device that is attached to front panel USB port.

Any mouse or keyboard that is connected to the KVM cable is disconnected

when you enable Smart Access USB.

• You can use USB 3.0-based devices, but they will operate at USB 2.0 speed.

• We recommend that the USB device have only one partition.

• The file system formats supported are: FAT16, FAT32, MSDOS, EXT2, EXT3, and EXT4. NTFS

is not supported.

• Enabled: the front-panel USB device is connected to the BMC.

• Disabled: the front-panel USB device is connected to the host.

Cisco APIC M4/L4 Server Installation and Service Guide

Smart Access USB