Cisco APIC M4 설치 및 서비스 매뉴얼 - 페이지 30

{카테고리_이름} Cisco APIC M4에 대한 설치 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco APIC M4 46 페이지.

Initial Server Setup

Figure 12: Reversing the CMA

CMA tab on end of width-adjustment slider

Initial Server Setup

Note

Server Default Settings

The server is shipped with these default settings:

• The NIC mode is Dedicated (the only supported option in APIC).

• The NIC redundancy is None for Dedicated NIC mode.

• DHCP is enabled.

• IPv4 is enabled.

Connection Methods

There are two methods for connecting to the system for initial setup:

• Local setup—Use this procedure if you want to connect a keyboard and monitor directly to the system

Cisco APIC M4/L4 Server Installation and Service Guide

This section describes how to power on the server, assign an IP address, and connect to server management

when using the server in standalone mode.

for setup. This procedure can use a KVM cable (Cisco PID N20-BKVM) or the ports on the rear of the

server.

Metal button on outside of tab

Installing the Server