B.W. Machinery BWM PRO 100 Series 사용자 설명서 - 페이지 12

{카테고리_이름} B.W. Machinery BWM PRO 100 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. B.W. Machinery BWM PRO 100 Series 20 페이지. Chipper shredder

5.2 Chipper Parts Regularly Checking

Check all the parts regularly (1-2 times a month) including bearing, blades, belt and

etc. Make sure the blades are sharp. Replace the blades as soon as the chipping

performance begins to deteriorate. Blunt blades will impact working efficiency and

cause damage to the machine.

❖ Stop the engine (Put the on/off switch in the "off" position) and disconnect the

safety switch cable.

❖ Remove the feeding chute. (Two people required)

❖ Put a block of wood into the hole (see Fig.1). Pull the starter cord some more

until the rotor is blocked. Now it is safe to unscrew blade bolts. Always use

gloves when handling the blades.

❖ Remove the blade anvil (see Fig.2).

❖ Give a really good clean of chipper blades and anvil and make sure there is no

dirt.

❖ Put anvil back to the chipper and screw on (make sure to keep anvil bolts loose as

you need to adjust it later).

❖ Use thread locker on blade bolts (make sure you don't use too much, normally

just a small dip) and screw on the blades (make sure all bolts are tightened).

❖ After installing the blades, check the gap between the blades and the anvil. The

gap should be no smaller than 0.5mm and not bigger than 1mm. (See Fig.3)

FIG 1

BWM PRO 100 Series Manual Book V1.01

B.W. Machinery

FIG 2

FIG 3

1 0