Final Touch Icy Wine Bar with PerfectTemp 운영 지침 - 페이지 2

{카테고리_이름} Final Touch Icy Wine Bar with PerfectTemp에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Final Touch Icy Wine Bar with PerfectTemp 2 페이지. Ewt-4 series

페이지 인쇄

Easy to Use (Operating instructions) (Continued)

The LCD will display the temperature:

a. The single line will indicate the current temperature of the wine

b. Three lines will indicate the ideal temperature based on the setting selected in step 3.

Now read the color of the LED lights

a. If the red LED is lit, it means either your wine is too Cool or too Warm.

b. If the green LED is ﬂashing it means that your wine is within ± 1°C (± 1.8°F) of the ideal serving

c. If the green LED is solid, it means that your wine is as the perfect temperature based on the

If the red LED is lit and the single line is above the three lines it means that your wine is too warm and it needs

to be chilled.

a. Place your wine bottle in the middle of the ice bucket and then ﬁll it with ice uniformly around

b. In approx 10 minutes a bottle of white wine at normal room temperatures (~21°C / ~70°F) should

THEREFORE FOR MAXIMUM COOLING EFFICIENCY WE RECOMMEND A MIXTURE OF WATER AND ICE

If the red LED is lit and the single line is below the three lines it means that your wine is too cool to be served

and it needs to be placed in a warmer environment. We do not recommend heating your wine. Please let your

wine stand in room temperatures to warm your wine.

LASTLY REMEMBER TO SHUT OFF THE WIRELESS TEMPERATURE SENSOR BY TURNING THE

POWER SWITCH TO "OFF" & THE ICE BUCKET UNIT BY PRESSING THE "POWER" BUTTON.

Cleaning Instructions

Remove the bucket insert to discard of the ice & water solution.

Rinse both the removable bucket insert & the Wireless Temperature Sensor under cold tap water.

IMPORTANT: rinse only the metal pickup portion of the wireless temperature sensor. If

the top portion of the sensor is exposed to liquids damage to the temperature sensor

will occur.

If necessary clean the Ice Bucket unit with a mild soap solution using a cloth. Wipe clean with a damp cloth.

WARNING: DO NOT SUBMERGE THE ICE BUCKET UNIT IN WATER. DOING SO WILL

PERMANENTLY DAMAGE THE ICY WINEBAR

Troubleshooting

In this section you can ﬁnd solutions to common problems by trying the suggestions below.

SYMPTOM

The ice bucket display is not showing any information

The unit is on but is not registering the temperature of

your wine

NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

temperature.

Perfect Temp system and it's ready to serve.

your wine bottle for even cooling. Additionally we recommend adding water to improve the

cooling performance.

be cooled enough, and within 4 minutes, a bottle of room temperature red wine will attain 17°C

(63°F) when using a mixture of water and ice.

Field strength 46.6dBµV/m at 3m

POSSIBLE CAUSE / SOLUTION

• The unit is off, press the power button

• The batteries are dead, replace the batteries (see

battery changing procedure above)

• The wireless temperature sensor is off, turn it on by

moving the power switch to "ON" position

• The wireless temperature sensor is more than 0.5

meters (20 inches) away from the ice bucket unit.

• The wireless temperature sensor battery is dead,

replace it (see battery changing procedure above)