Cisco Expressway CE1200 설치 매뉴얼 - 페이지 5

{카테고리_이름} Cisco Expressway CE1200에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Expressway CE1200 23 페이지.
Cisco Expressway CE1200에 대해서도 마찬가지입니다: 어플라이언스 설치 매뉴얼 (42 페이지)

페이지 인쇄

1. Connect to the Expressway Console

Cisco Expressway CE1200 Appliance Installation Guide

Introduction

This guide describes how to install a CE1200 appliance into a video network, including how to prepare and install the

hardware, and how to do the basic initial configuration. It also provides some troubleshooting suggestions.

Note:

The guide is for Cisco Expressway Series deployments only, as the appliance does not support the Cisco VCS

product.

Required Software Version

The CE1200 ships with pre-installed Expressway software. If you need to in future, you can upgrade the pre-installed

software to a later supported version. (If you want to check whether the Cisco Expressway has the latest software

installed, go to

http://software.cisco.com/download/navigator.html

CAUTION:

The CE1200 appliance requires Expressway software version X8.11.1 or later. Although the system will

not prevent downgrades to an earlier software version, Cisco does not support appliances that are running

earlier versions. This requirement applies to any UCS C220 M5L-based appliance.

System Sizes Supported

The appliance can support either a Large or a Medium Expressway system.

What's Different?

If you deploy existing CE500, CE1000, or CE1100 appliances, this section highlights some of the differences in the

CE1200:

The CE1200 is designed for use with the Cisco Expressway Series product range, and does not support the

■

Cisco VCS product. It ships with the release key pre-installed.

Unlike earlier appliances, the CE1200 is a single, multi-purpose server that can operate as a Cisco

■

Expressway-C or a Cisco Expressway-E. By default it always ships with Expressway-C preinstalled. To deploy

the server as an Expressway-E, you configure the Type option as Expressway-E, in the Service Setup Wizard

(the wizard runs when you first launch the Expressway web user interface, or you can run it anytime from the

Status > Overview page). The Traversal Server option key is no longer used to change to an Cisco

Expressway-E.

The CE1200 can support up to 5000 registrations for Mobile and Remote Access, an increase on the 2500

■

MRA registrations supported by other physical appliances or VM-based systems.

To add a CE1200 appliance to an existing cluster that has CE1100 models in it, configure the Type option to match

the other peers (Expressway-E or Expressway-C) through the service setup wizard on the Status > Overview page,

before you add the CE1200 to the cluster.

More Information and Training

Training:

training is available online and at our training locations. Information about the courses we provide and the

location of our training offices is at

Glossary:

a glossary of TelePresence terms is at