Cisco Expressway CE1200 어플라이언스 설치 매뉴얼 - 페이지 31

{카테고리_이름} Cisco Expressway CE1200에 대한 어플라이언스 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Expressway CE1200 42 페이지.
Cisco Expressway CE1200에 대해서도 마찬가지입니다: 설치 매뉴얼 (23 페이지)

페이지 인쇄

Connect to Expressway Console

Task 2: Run CIMC from a remote host and enable Serial over LAN (once only)

Step 1

In a web browser, go to the CIMC IP address you configured in the previous task.

Step 2

Do one of the following:

• If you use a static IP address, log in using the password you set in Task 1.

Note

If the new password you set in Task 1 was not strong enough, because of the known issue with the system

failing to notify you at the time, you are now prompted to enter the default password and then to set a

different, strong, password before you can continue. The new password must match the conditions in

Connecting Using CIMC Serial Over

• If you use DHCP, define a strong password to replace the supplied default. The new password must match the

conditions in

Step 3

Click the menu arrow in the top-left corner.

Step 4

Navigate to Compute > Remote Management > Serial over LAN

Step 5

In the Serial over LAN Properties, check Enabled and then click Save Changes. This step is necessary as serial over

LAN is disabled by default.

Task 3: Connect to the Expressway console (any time you need to)

Step 1

In a terminal emulator, use SSH to connect to the CIMC IP address.

Step 2

Type the default username admin and your CIMC password, and press Enter.

Step 3

Type connect host and press Enter.

Step 4

You are now connected to the Expressway console using serial over LAN.

Wait for the Install Wizard to appear, and go to the section

Connecting Using CIMC Serial Over

Task 2: Run CIMC from a remote host and enable Serial over LAN (once only)

LAN.

Run the Install Wizard

Cisco Expressway CE1200 Appliance Installation Guide (14.0)