Cisco Firepower 1120 하드웨어 설치 매뉴얼 - 페이지 26

{카테고리_이름} Cisco Firepower 1120에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 1120 42 페이지. Connected grid router
Cisco Firepower 1120에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (30 페이지), 설치 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (10 페이지), 매뉴얼 (6 페이지), 배포 매뉴얼 (8 페이지), 시작하기 (42 페이지), 하드웨어 설치 매뉴얼 (42 페이지)

Cisco Firepower 1120 하드웨어 설치 매뉴얼

Maintain Safety with Electricity

• Do not wear loose clothing or jewelry, such as earrings, bracelets, or chains that could get caught in the
• Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
• Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
• Never attempt to lift an object that is too heavy for one person.
Maintain Safety with Electricity
Warning
Read the
Follow these guidelines when working on equipment powered by electricity:
• Before beginning procedures that require access to the interior of the chassis, locate the emergency
• Do not work alone if potentially hazardous conditions exist anywhere in your work space.
• Never assume that power is disconnected; always check.
• Look carefully for possible hazards in your work area, such as moist floors, ungrounded power extension
• Use the chassis within its marked electrical ratings and product usage instructions.
• The chassis is equipped with an AC-input power supply, which is shipped with a three-wire electrical

Prevent ESD Damage

ESD occurs when electronic components are improperly handled, and it can damage equipment and impair
electrical circuitry, which can result in intermittent or complete failure of your equipment.
Always follow ESD-prevention procedures when removing and replacing components. Ensure that the chassis
is electrically connected to an earth ground. Wear an ESD-preventive wrist strap, ensuring that it makes good
skin contact. Connect the grounding clip to an unpainted surface of the chassis frame to safely ground ESD
voltages. To properly guard against ESD damage and shocks, the wrist strap and cord must operate effectively.
If no wrist strap is available, ground yourself by touching the metal part of the chassis.
For safety, periodically check the resistance value of the antistatic strap, which should be between one and
10 megohms.
Cisco Firepower 1100 Series Hardware Installation Guide
22
chassis.
Before working on a chassis, be sure the power cord is unplugged.
Regulatory and Compliance Information
power-off switch for the room in which you are working. Then, if an electrical accident occurs, you can
act quickly to turn off the power.
cables, frayed power cords, and missing safety grounds.
cord with a grounding-type plug that fits into a grounding-type power outlet only. Do not circumvent
this safety feature. Equipment grounding should comply with local and national electrical codes.
document before installing the chassis.
Installation Preparation