Cisco Firepower 1120 하드웨어 설치 매뉴얼 - 페이지 33

{카테고리_이름} Cisco Firepower 1120에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 1120 42 페이지. Connected grid router
Cisco Firepower 1120에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (30 페이지), 설치 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (10 페이지), 매뉴얼 (6 페이지), 배포 매뉴얼 (8 페이지), 시작하기 (42 페이지), 하드웨어 설치 매뉴얼 (42 페이지)

Connect to the Console Port

•

You must install a USB device driver the first time a Microsoft Windows-based PC is connected to the USB

console port on the chassis, otherwise the connection fails.

To uninstall the driver, use the Add Remove Programs utility or the Setup-exe program.

Note

Step 1

Obtain the appropriate driver (Cisco_usbconsole_driver_X_X_zip, where X is a revision number) for your model from

the Cisco

Download Software

Note

The download site redirects you to a router download section where the drivers are also applicable to Firepower

products. The drivers are OS-specific and not tied to the vendor of the console cable manufacturer.

Step 2

Install the driver.

Step 3

Connect a 5-pin USB Mini B to the console port as shown in the following figure.

Connect to the Console Port with Microsoft Windows, on page 29

Connect to the Console Port with Mac OS X, on page 31

Connect to the Console Port with Linux, on page 31

Disconnect the console terminal before uninstalling the driver.

site, USB Console Software category.

C H A P T E R

Cisco Firepower 1100 Series Hardware Installation Guide