Cisco Firepower 1120 하드웨어 설치 매뉴얼 - 페이지 9

{카테고리_이름} Cisco Firepower 1120에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 1120 42 페이지. Connected grid router
Cisco Firepower 1120에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (30 페이지), 설치 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (10 페이지), 매뉴얼 (6 페이지), 배포 매뉴얼 (8 페이지), 시작하기 (42 페이지), 하드웨어 설치 매뉴얼 (42 페이지)

Overview

Note

External Flash Storage

Package Contents

The following figure shows the package contents for the Firepower 1100. Note that the contents are subject

to change, and your exact contents might contain additional or fewer items.

Note

For Windows operating systems, you must install a Cisco Windows USB Console Driver on any PC

connected to the console port before using the USB console port. See

Microsoft Windows, on page 29

The chassis contains a standard USB Type A port that you can use to attach an external device. The USB

port can provide output power of 5 volts, up to a maximum of 1 A (5 USB power units).

• External USB drive (optional)—You can use the external USB Type A port to attach a data-storage

device. The external USB drive identifier is disk1. When the chassis is powered on, a connected

USB drive is mounted as disk1 and is available for you to use. Additionally, the file-system

commands that are available to disk0 are also available to disk1, including copy, format, delete,

mkdir, pwd, cd, and so on.

• FAT-32 File System—The Firepower 1100 only supports FAT-32-formatted file systems for the

external USB drive. If you insert an external USB drive that is not in FAT-32 format, the system

mounting process fails, and you receive an error message. You can enter the command format

disk1: to format the partition to FAT-32 and mount the partition to disk1 again; however, data might

be lost.

There are three sets of four screws that you can use to secure the chassis to your rack. Chose the screws that

fit your rack.

for information on installing the driver.

Cisco Firepower 1100 Series Hardware Installation Guide

Connect to the Console Port with